Rc quickcal update manual#
Rc quickcal update upgrade#

Connect the USB cable to a computer or to the AC/USB power supply.

Calls always have higher priority, so the loading of the web interface can be slow during an ongoing call. It can happen when the web interface is loading, and openSPOT is in a call simultaneously. Note that the ACT LED is also acting as a “heartbeat”, if it’s blinking very slowly that means the main CPU is very busy at the moment.

Rc quickcal update upgrade#

For further information, refer to the Firmware upgrade section below. Retry firmware upgrade with the correct firmware upgrade file. If you reboot openSPOT and the ACT and STATUS LEDs are blinking red by turns, you’ve uploaded a firmware file with an incorrect hardware version. If main CPU firmware upgrade is in progress, the STATUS LED is toggling fast between red and green states, if modem CPU firmware upgrade is in progress, the MODEM LED is toggling fast between red and green states. If the ACT LED is unlit, and both the STATUS and MODEM LEDs are blinking fast green, openSPOT is in bootloader mode. Unlit: modem is idle, or searching for sync.If it doesn’t help, try to upgrade firmware. Fast blinking red: modem CPU not found.Slow blinking red: modem CPU version mismatch.Fast toggling between red and green: modem CPU firmware upgrade is in progress.Fast blinking green: modem CPU communicating with main CPU.Slow blinking green: modem CPU found and is ready.Continuously green: connector is connected.Blinking red: connector is trying to connect.The STATUS LED shows openSPOT’s connector status:.It works even when openSPOT is running the bootloader. The ETHERNET LED is wired to the Ethernet controller, so it’s always green when an Ethernet cable is plugged in, and always blinking green, when it’s communicating.(The usage of inappropriate power supplies voids the warranty) Interfaces Please use only the supplied power supply. These are all you need to operate openSPOT, however, you will need a web browser on a computer, tablet or mobile phone for initializing openSPOT settings, but after that, openSPOT can work standalone. The openSPOT package comes with an AC/USB power supply, an antenna, a USB and an Ethernet cable. We only have these two official support platforms (we don’t have official support on Facebook or other platforms). If you have questions, please ask them on our forum or in email.

Rc quickcal update manual#

Note that this user manual is for openSPOT firmware version v142. Home > Products > openSPOT > openSPOT User Manual openSPOT User Manual